Repairing Faulty Renault Clio Key Fobs
Renault has revolutionized the Clio in its fifth generation. The interior of the new Clio is better than the previous model, and also has a more refined driving environment.
It also has one the largest infotainment displays in this class, ranging between 7 and 10 inches, depending on the specs. It's also loaded with additional features that make it a highly competitive mini.
Dead coin battery
If your Clio key fob isn't functioning, you can replace the battery. The battery is typically a button cell type and can be replaced at home. However, it is essential to use the correct voltage, size and type of battery for the job. Do not let the battery touch your skin. This can damage the electronic chip in the key fob due to moisture and oils.
Normally the battery is likely to begin to fail before it completely is dead. You might notice that the car doesn't start when you push the ignition switch to turn it on. Then the key fob won't be able to click, but it won't crank. This is a sign that the battery on the coin is close to reaching its end of life.
Another possible reason for the key fob not functioning is interference. It could be caused by transmitters in the same frequency, bad weather conditions, or faulty electronic components. The remote control may work when you are close to the vehicle, but it will not work from a distance.
If your key fob does not work it can be reset by taking out the 12 volt battery for a couple of minutes. Make sure to remove the negative terminal first and then the positive terminal. This will rid the system of any residual electrical energy.
Water damage
The Renault Clio is a great little car with lots of personality and decent tech. However, there are a few issues that can crop up with this tiny French car, especially with regard to key fobs. These devices can be difficult to handle, but there are ways to stay clear of them.
Electronics and water don't get along well and can cause damage to the chip inside the fob. A splash of rainwater or even a bath is likely to be fine, however submerging it in a pool or ocean could cause the chips to fail. This is especially the case if salt is present in the water, which could be more harmful than pure tap water.
If your key fob has been submerged in water, it's recommended to clean it as soon as you can with isopropyl or electronic cleaner. This will stop the water from damaging the chip and also remove any dirt, grime or oil that might be clogging up the circuitry.
You can try to fix your fob by changing the battery once it is dry. If you're unable to make it work then it's best to purchase a new fob instead of trying to repair it. Do not buy second-hand keys on eBay as they won't be programmed for your vehicle.
Key fobs that are defective
Key fobs that are not working properly can cause issues with the RKE system of your car, such as not locking the doors or starting the vehicle. In some instances the issue is caused by interference from wireless devices that transmit at the same frequency as the key fob. These include radar detectors from aftermarket and alarms. They can interfere with the signal of the key fob to the receiver module.
The first thing you need to check when your key fob isn't working is its battery. Modern key fobs are equipped with batteries that are designed to last for a long time, but they will eventually degrade and require to be replaced. One of the main signs that a keyfob's battery is worn out is the loss of signal strength and range.
You can replace the battery in a key fob yourself by following a few simple steps. YouTube has many videos and directions on how to replace a battery in your car model.
If you cannot replace the battery in your key fob, you should try to start the car using the backup system, which is feasible in a variety of vehicles. In the majority of cases, this involves closing the doors of the car and pressing the start button on the fob using the physical key. If you are unable start your car using this method an expert or a an expert to pinpoint the issue.
The receiver module is not working properly.
The Renault Clio's remote keyless system could stop working when the receiver module is defective. It can also affect other systems in the car, for example the infotainment system. The issue could be caused by a dead 12-volt battery, signal interferance or a defective chip. To solve this issue first, remove the 12 volt battery from the vehicle. Use a multimeter and check the voltage of each fuse in your fuse box. Replace any fuse that has damaged.
The most common reason for a malfunctioning Renault Clio remote key is an empty coin battery. The issue could be caused by worn buttons or a poor connection of the batteries with the metal clips on the key fob, or water damage. You can usually replace the battery by following the directions in your owner's manual. renault key fob battery change is important to ensure that the battery replacement is the right size and voltage.
The key fob's internal chip is susceptible to damage due to water damage or exposure to sunlight or other electromagnetic fields. It is also susceptible to being damaged by radio transmitters that operate on the same frequency of the key fob. In these cases, the transmitter of the key fob will work locally but not from an extended distance. You can fix this issue by reprogramming your key with an OBDII scanner or following the instructions provided in your owner's guide.